Toshiba Magnia 3310 - Manual (Page 216)

Troubleshooting
Troubleshooting 200
4 Are all the power cables for the server and display unit
connected correctly to a grounded AC outlets?
See “Connecting the power cable” on page 39.
5 Is the power indicator ( ) lit amber?
6 Turn the display unit on and adjust the maximum values for
brightness and contrast.
See the operating manual of the display unit.
7 When running Windows Server 2003/Windows 2000, boot up
in the VGA mode, and ensure that the settings (resolution,
synchronizing frequency) are as supported by the display unit.
Characters are distorted or not displayed properly
Probable causes are faulty connection of the display signal cable
or power cable, or a problem with the brightness or contrast
settings. Carry out the following procedure to check the cause of
the trouble. If this does not remedy the problem, turn off the power
first, and then see“Remedy When Windows Server 2003/
Windows 2000 is unusable” on page 210.
1 Is the display unit connected correctly to the server?
If the switch box is used on a rack model, also check the
connections with other devices and check that the server is
selected correctly.
See “Connecting peripheral devices” on page 37.
2 Turn the display unit on and adjust the maximum values for
brightness and contrast.
See the operating manual of the display unit.
3 When running Windows Server 2003/Windows 2000, boot up
in the VGA mode, and ensure that the settings (resolution,
synchronizing frequency) are as those supported by the display
unit.