Toshiba Magnia 3310 - Manual (Page 138)

Installing and Removing Hardware
SCSI device 120
4 Put your fingers on both sides of the SCSI device, and pull out
it slightly toward you while pushing the hooks.
Pulling the SCSI device out of the device bay
5 Remove the power and signal cables.
Removing the cables
6 Pull out the SCSI device completely.
7 Detach the rails from the SCSI device.
8 Attach the rails to the device bay spacer and secure them with
two screws each.
9 Install the device bay spacer.
10 Fit the panels to the server.
See “Removing and replacing the server panels” on page 25.
11 Connect all the power cables of the server to the power supply,
and switch on the server.