Toshiba Magnia 3310 - Manual (Page 191)

Installing Software
Windows Server® 2003 174
1 Press in the startup screen to start the BIOS setup utility,
then select “CD-ROM Drive” from the boot menu.
2 Press <+> to increase the CD-ROM drive’s order in the boot
sequence.
Press <+> to move “CD-ROM Drive” to a higher order in the
boot sequence than “+Hard Drive”.
3 Press , then to end BIOS setup.
When you press , the changes are saved, and the system
restarts.
Selecting the disk driver
Selecting the IDE CD-ROM Controller driver
No special operations are required as the driver contained on the
CD-ROM of the Windows Server 2003 Server is used.
Selecting a driver for the RAID controller
Only when the RAID controller is connected, follow the
procedure mentioned below.
1 When the Windows Server 2003 Setup screen appears and
"Press F6..." is displayed in the lower left hand corner of the
screen, press the F6 key.
2 When a message appears on the screen, asking whether you
want to add a device driver for mass storage device, press the
key.
+Removable Devices
+Hard Drive
CD-ROM Drive
Network Boot
+Removable Devices
CD-ROM Drive
+Hard Drive
Network Boot