Toshiba Magnia 550d - Manual (Page 96)

Connecting Hardware Devices
Hard disk drive (HDD) – SCSI HDD –
79
10 Install the drive carrier in the server and secure it with two
screws.
Engage the rail on the top of the drive carrier with that of the
server, and push the drive carrier in the direction of the server’s
rear side until you feel a click.
Installing the drive carrier
11 Firmly plug in the power cable and signal cable.
12 Replace the side panel and front door panel.
13 Plug in the power cable and switch on the server.
Removing a hard disk drive –3.5-inch device bay–
When removing a hard disk drive from the server, first read
“Before you start” of this chapter and follow the instructions given
below.
1 If the server is in operation, shut it down and switch off the
power.
2 Unplug the power cable.
NOTE: Removing a hard disk drive while the server is turned
on may cause damage to the server or the hard disk drive.
3 Remove the front door panel and side panel.