Toshiba Magnia 550d - Manual (Page 106)

Connecting Hardware Devices
SCSI devices
89
Removing a SCSI device out of the 5.25-inch device bay
When removing a SCSI device, first read “Before you start” of this
chapter and follow the instructions given below.
1 If the server is in operation, shut it down and switch off the
power.
2 Unplug the power cable.
NOTE: Removing a SCSI device while the server is turned on
may cause damage to the server or to the SCSI device.
3 Remove the front door panel and the side panel.
See “Removing and replacing the server panels” on page 21.
4 Remove the two screws securing the SCSI device to the server,
and partially remove the SCSI device from the device bay.
5 Unplug the power cable and signal cable.
6 Completely remove the SCSI device out of the device bay.
7 Restore the 5.25-inch shield cover to its original position and
fasten it using the screw.
8 Fit the device bay slot spacer to the front door panel.
9 Replace the side panel and front door panel.
10 Plug in the power cable and switch on the server.