Toshiba Magnia 550d - Manual (Page 162)

Installing Software
NetWare
146
NetWare
Before installing the NetWare
If the Server Setup Tool is used, it automatically carries out setup
of the RAID (disk array) as well as installation of the MS-DOS. In
other words, the Server Setup Tool automatically prepares the
installing environment for the NetWare.
Alternatively, an MS-DOS disk can be created by using the Server
Setup Tool so that the MS-DOS environment can be set up
manually without the use of the DOS Installer of the Server Setup
Tool.
Settings of the motherboard
Check the settings of the motherboard. Start the BIOS Setup
Utility, select “PNP/PCI Configuration,” and ensure the following
setting is entered:
Plug and Play Aware O/S : NO
Preparation of a floppy disk
To install the NetWare, you need to have previously copied each
driver to a floppy disk, using the Server Setup Tool.
Start Server Setup Tool, select “Utilities” and “Creating FDs,” and
copy the following drivers to floppy disks:
DOS Disk
-Adaptec 29160N NetWare Driver
-D-Link 530LTX NetWare Driver
Setup of the MS-DOS environment
The environment to install the NetWare can be set up in three ways
as follows:
(1) Install MS-DOS by using the Server Setup Tool so that the
installation environment for the NetWare is automatically set