Toshiba Magnia 550d - Manual (Page 150)

Installing Software
Windows NT
® Server 4.0
134
4 Select the name of the backup floppy disk you want to create,
and click “Create.”
5 Insert a 1.44 MB-formatted floppy disk in the floppy disk
drive, and click “OK.”
Remove the Startup Disk floppy disk from the floppy disk
drive beforehand.
Here are the drivers that you should copy for backup:
-Adaptec 29160N Windows NT Driver
(if a SCSI controller-Adaptec 29160N is installed)
-D-Link 530LTX Windows NT Driver
(if a Network Adapter-DFE-530LTX is installed)
NOTE: Store the backup floppy disks in a safe place.
Selecting disk drivers
Selecting a driver for the SCSI controller
(if a SCSI controller is installed)
To select a driver for the SCSI controller, proceed as follows:
1 When the Windows NT Server 4.0 Setup Disk 2 displays a
message asking whether or not to detect large capacity storage
devices, select “S=Skip Detection.”
2 Select “S=Specify Additional Device.”
3 Select “Others (Requires disk provided by a hardware
manufacturer).”
4 Insert the SCSI Controller Driver backup floppy disk created
using the Server Setup Tool in the floppy disk drive, and press
the key.
Use the Adaptec 29160N Windows NT Driver floppy disk.
5 In the window that appears, select the following drivers:
Adaptec Ultra160 Family PCI SCSI Controller (NT4.0)
Selecting a driver for the RAID controller
(If a RAID controller MR475 is installed)