Toshiba Magnia 550d - Manual (Page 203)

189
3 Switch on the server.
After the CMOS is cleared, all setup information is lost and the
following window appears.
Press the key, then follow the steps below to reset the CMOS
to its default settings.
1 Select “LOAD OPTIMIZED DEFAULTS” from the Setup
menu to activate it.
2 Set the system date and time under “STANDARD CMOS
SETUP” in the Setup menu.
3 Set the following, using “BIOS FEATURES SETUP” in the
Setup menu.
S.M.A.R.T. for Hard Disks: Enabled
4 Set the following, using “CHIPSET FEATURES SETUP” in
the Setup menu.
SDRAM Timing by SPD: Enabled
DRAM Integrity Mode: Ecc
USB Controller: USB Port 0&1
5 If Windows 2000 Server is installed, set the following, using
“PNP/PCI CONFIGURATION.”
Plug and Play Aware O/S: Yes
CMOS Setting Wrong
CMOS/GPNV Checksum Bad
Press F1 to RUN SETUP
Press F2 to load defaults values and continue