Characters are distorted or not displayed properly, The disk indicator turns on abnormally – Toshiba Magnia 550d User Manual
Page 176
Troubleshooting
Troubleshooting
160
See the operating guide of the display unit.
6 When running Windows NT/2000, boot up in the VGA mode,
and ensure that the settings (resolution, synchronizing
frequency) are as supported by the display unit.
Characters are distorted or not displayed properly
Probable causes are faulty connection of the display signal cable
or power cable, or a problem with the brightness or contrast
settings. Carry out the following procedure to check the cause of
the trouble. If this does not remedy the problem, see“Remedy
When Windows NT/2000 is Unusable” on page 167.
1 Is the display unit connected correctly to the server?
If the switch box is used on a rack model, also check the
connections with other devices and check that the server is
selected correctly.
See “Connecting peripheral devices” on page 28.
2 Turn the display unit on, and set the brightness and contrast to
two thirds of the their maximum value or more.
See the operating guide of the display unit.
3 When running Windows NT/2000, boot up in the VGA mode,
and ensure that the settings (resolution, synchronizing
frequency) are as those supported by the display unit.
The disk indicator turns on abnormally
A probable cause is that a hard disk drive connected to the RAID
controller is malfunctioning. If Windows NT/2000 can be used
after checking from the lit state of the disk indicator which hard
disk drive is malfunctioning, proceed to “Remedy When
Windows NT/2000 is Usable” on page 166.
If Windows NT/2000 cannot be used, proceed to “Remedy When
Windows NT/2000 is Unusable” on page 167.