Toshiba Magnia 550d - Manual (Page 170)

Installing Software
NetWare
154
LAN drivers,” and select “Deselect a selected driver” to delete the
drivers.
Selecting the SCSI Controller driver
(when the SCSI controller is installed)
Proceed as follows:
1 Move the cursor to “Select additional or modify selected Disk/
LAN drivers” on the screen shown above with the arrow keys,
and press the key.
2 Insert the Adaptec 29160N NetWare Driver created with
Server Setup Tool in the floppy disk drive.
3 Select “Select an additional driver” first, and select “Install an
unlisted driver ” next.
4 Press the key to retrieve drivers contained on the
floppy disk.
5 When the driver list appears, select the following driver.
Proceed with the installing operation following the instructions
that appear on the screen.
NOTE: Selection of the slot numbers (2 in usual) is shown by
the System Console.
These numbers vary depending on the system configuration.
Selecting the RAID Controller driver
(when the RAID controller MR475 is installed)
After selecting the driver following the procedure of the previous
section “Selecting the SCSI Controller driver,” proceed as follows:
1 Select “Select an additional driver.”
|| ADPT160M.HAM ||Adaptec 29160N Ultra160 SCSI Host Adapter