Toshiba Magnia 550d - Manual (Page 171)

Installing Software
NetWare
155
2 Set the floppy disk labeled “MegaRAID Drivers for Series
493/475 NetWare/MS-DOS” (supplied with the RAID
Controller) in the floppy disk drive.
3 Select “Install an unlisted driver ” by pressing the
key.
4 Press the key and specify the following directory under
the floppy disk drive.
A: \NetWare
5 Press the key to retrieve drivers contained in the
floppy disk.
6 When the driver list appears, select the following driver.
Proceed with installing operation, following the instructions
that appear on the screen.
Selecting the Network Adapter driver
Use the following file contained in the D-LINK 530LTX Netware
Driver floppy disk created with Server Setup Tool as the NetWare
Adapter driver.
A: \DLKFET.LAN
Procedure after installation of the NetWare
Setup of the RAID Controller Utility
If the RAID controller is connected with the server, be sure to set
up the “MegaRAID Manager” that is a RAID Controller Utility
after installing the NetWare. If the MegaRAID Manager is not set
up, the system cannot be recovered from a disk during operation.
See “MegaRAID Software Guide” for details of the MegaRAID
Manager.
|| MEGA4_XX.HAM ||AMI MegaRAID Enterprise 1600/1700/Express 500 Adap ||