Toshiba Magnia 550d - Manual (Page 128)

System Configuration Setup
BIOS Setup Utility
112
$ 1st Boot Device : Floppy
2nd Boot Device : IDE-0
3rd Boot Device : CDROM
Used to set the start-up sequence for the boot devices.
Floppy ............... Boots up the system from the floppy disk.
LS/ZIP A:........... Boots up the system from the LS/ZIP A
drive.
CDROM............. Boots up the system from the CD-ROM.
SCSI ................... Boots up the system from a SCSI device.
NETWORK....... Boots up the system over the network.
IDE-0 ~ IDE-3... Boots up the system from the IDE-0, IDE-1,
IDE-2, or IDE-3 device.
Disabled ............. Invalid
ATAPI ZIP C: .... Boots up the system from the ATAPI ZIP C
drive.
$ S.M.A.R.T. for Hard Disks : Enabled
Used to set the Self-Monitoring Analysis and Reporting
Technology (S.M.A.R.T.) feature of hard disk drives. Your
system displays a S.M.A.R.T. message when you start the
BIOS.
Enabled .............. Enables the S.M.A.R.T.
Disabled ............. Disables the S.M.A.R.T.
$ BootUp Num-Lock : On
Used to specify whether to enable the num-lock function of the
keyboard when you start your system.
On....................... Enables the num-lock function.
Off ...................... Disables the num-lock function.