Toshiba Magnia 550d - Manual (Page 65)

Connecting Hardware Devices
Installing and removing optional devices
48
Installing and removing methods
WARNING: Do not open or disassemble any part other than
those described in this manual, otherwise you may be
vulnerable to an electric shock.
When installing or removing an optional device, proceed as
follows:
1 Check the precautions mentioned in “Before you start” of this
chapter.
2 If the server is in operation, shut it down and switch off the
power.
3 Switch off all the peripheral devices connected to the server.
4 Unplug the power cable from the AC outlet or uninterruptible
power supply (UPS), then disconnect all cables from the
connectors at the rear of the server.
5 Remove the server panels.
See “Removing and replacing the server panels” on page 21.
6 Install or remove an optional device.
7 Ensure that no tools or removed parts are left inside the server.
8 Replace the server panels.
9 Connect the peripheral devices to the server and switch them
on.
10 Plug the power cable into the AC power connector and the AC
outlet, and switch on the server.
Some optional devices require you to reconfigure the server
and to change the jumper switch or DIP switch settings.
See “System Configuration Setup” on page 104.
See the operating guide of the peripheral devices.