Toshiba Magnia 550d - Manual (Page 107)

Connecting Hardware Devices
SCSI devices
90
Installing a SCSI device in the 3.5-inch device bay
The 3.5-inch device bay is capable of incorporating a maximum of
2 built-in type 3.5-inch SCSI devices.
When installing a SCSI device, first read “Before you start” of this
chapter and follow the instructions given below.
1 If the server is in operation, shut it down and switch off the
power.
2 Unplug the power cable.
NOTE: Installation of a SCSI device while the server is turned
on may cause damage to the server or the SCSI device.
3 Remove the front door panel and side panel.
See “Removing and replacing the server panels” on page 21.
4 Enter the SCSI ID of the SCSI device to be installed.
5 Disconnect the power cable and signal cable from the hard
disk drive and the floppy disk drive.
6 Remove the two screws securing the drive carrier. While
pressing the latch down, slide the drive carrier in the direction
of the server’s front side and remove it.
Removing the drive carrier