Installing a memory module, 2 unplug the power cable, 3 remove the front door and side panel – Toshiba Magnia 550d User Manual
Page 68
Connecting Hardware Devices
Memory modules
51
CAUTION: Never install or remove a memory module after
just turning off the server. To avoid burn injuries, wait for the
heat around the memory modules to dissipate.
When installing a memory module, be sure to first unplug the
power cable of the server. Installing a memory module while
the server is on could cause damage to the server or to the
memory module.
Memory modules can be seriously damaged by static
electricity because they are precise electronic devices.
Before installing a memory module, lightly touch a metallic
part of the server to discharge any static electricity from your
body.
Installing a memory module
When installing a memory module, first read “Before you start” of
this chapter and follow the instructions described below.
1 If the server is in operation, shut it down and switch off the
power.
2 Unplug the power cable.
NOTE: Installation of a memory module while the server is
switched on may damage the server or the memory module.
3 Remove the front door and side panel.