Toshiba Magnia 550d - Manual (Page 30)

Getting Started
Front view (with the front doors opened)
13
$ Eject hole
Used to eject the disk tray if it does not slide out while you
press the eject button. Insert a fine wire (e.g., straightened
paper clip) into this hole to forcefully eject the tray.
NOTE: Be sure to turn off the server beforehand when
ejecting the disktray using the eject hole.
Do not insert any fragile pin, such as a mechanical pencil lead
or a plastic pin.
Do not press the eject button when the CD-ROM drive status
indicator is lit. Otherwise, the CD-ROM drive might fail.
After using the CD-ROM drive, always remove the CD-ROM
from it.
The disk trays of some CD-ROM drives are provided with
disk holders. Do not use the disk holder along with this
system, except when the system is used as a rack model.
When ejecting the disk tray without using the eject button or
eject hole, open the front door beforehand.
3.5-inch device bay
The 3.5-inch device bay can accommodate up to three 3.5-inch
devices. (One of the three slots is already occupied by a floppy
disk drive and one or two slots by other magnetic disk drives.)
Floppy disk drive
The floppy disk drive supports 3.5-inch 2DD (720 kB) and 2HD
(1.44 MB) floppy disks.