Toshiba Magnia 550d - Manual (Page 111)

Connecting Hardware Devices
SCSI devices
94
14 Replace the side panel and front door panel.
15 Plug in the power cable and switch on the server.
Removing a SCSI device out of the 3.5-inch device bay
When removing a SCSI device, first read “Before you start” of this
chapter and follow the instructions mentioned below.
1 If the server is in operation, shut it down and switch off the
power.
2 Unplug the power cable.
NOTE: Removing a SCSI device while the server is turned on
may cause damage to the server or the SCSI device.
3 Remove the front door panel and side panel.
See “Removing and replacing the server panels” on page 21.
4 Unplug the power cable and signal cable.
5 Remove the two screws fastening the drive carrier. While
pressing the latch down, slide the drive carrier in the direction
of the server’s front side and then remove the drive carrier.
NOTE: When removing the drive carrier, be careful not to
catch the cables on the drive carrier or touch the memory
unit.
6 Remove the SCSI device from the device bay.
7 Restore the 3.5-inch shield cover to the original position.
8 Install the drive carrier in the server and fasten it using 2
screws.
Engage the rail on the top of the drive carrier with the rail of
the server, and push the drive carrier in the direction of the
server’s rear side until you feel a click.