Toshiba Magnia 550d - Manual (Page 79)

Connecting Hardware Devices
CPU module
62
6 Remove the CPU module.
Removing a CPU module
7 Install a new CPU module in the same manner as described in
the installation of an additional CPU module.
NOTE: Do not push the fin section of heat sink of the CPU
module. This may cause the deformation of the heat sink.
Do not detach the heat sink once attached. The cooling
efficiency of a heat sink decreases if detached and
reattached. Therefore, if the heat sink is detached for some
reason, do not reattach it but replace it with a new one.
8 Set SW2 dip switch on the motherboard. Set SW2 dip switch
to configure the server to the processing speed of the CPU
module. See the table on the next page.