Toshiba Magnia 550d - Manual (Page 103)

Connecting Hardware Devices
SCSI devices
86
Installing a SCSI device in the 5.25-inch device bay
The 5.25-inch device bay is capable of incorporating a maximum
of three built-in type 5.25-inch SCSI devices.
When installing a SCSI device, first read “Before you start” of this
chapter and follow the instructions given below.
1 If the server is in operation, shut it down and switch off the
power.
2 Unplug the power cable.
NOTE: Installation of a SCSI device while the server is turned
on may cause damage to the server or to the SCSI device.
3 Remove the front door panel and side panel.
See “Removing and replacing the server panels” on page 21.
4 Enter the SCSI ID of the SCSI device to be installed.
5 Fit two rails to the SCSI device to be installed and fasten each
rail using two screws.
Use the screw B supplied with the server.
See “Before you start” on page 43.
Fitting rails to a SCSI device