Toshiba Magnia 550d - Manual (Page 85)

Connecting Hardware Devices
Hard disk drive (HDD) – IDE HDD –
68
Jumper switch setting for hard disk drives
When connecting hard disk drives to the server’s IDE interface, set
the jumper switch on each hard disk drive according to its identity
as master or slave.
For connecting an expansion hard disk drive with
the primary IDE interface
Set the first magnetic drive to Master (drive 0), and the second
drive to Slave (drive 1).
See the Addendum sheet of the hard disk drive.
Points of connection
$ When installing an additional IDE HDD in the server, follow
the instructions as shown in the table below.
$ IDE and SCSI hard disk drives cannot be connected to the
server at the same time.
$ Do not connect any hard disk drive with the secondary IDE
interface.
Installing a hard disk drive (expansion)
When installing a hard disk drive in the server, first read “Before
you start” of this chapter and follow the instructions given below.
1 If the server is in operation, shut it down and switch off the
power.
2 Unplug the power cable.
Primary IDE interface Secondary IDE interface
Master Slave Master
1st magnetic
drive (Drive 0) 2nd magnetic
drive (Drive 1) CD-ROM drive connected