Toshiba Magnia 550d - Manual (Page 138)

System Configuration Setup
BIOS Setup Utility
122
$ VGA Boot from : AGP
Used to specify a VGA card used for startup.
AGP.................... Uses the VGA card in an AGP slot for
startup.
PCI...................... Uses the VGA card in a PCI slot for startup.
$ PCI VGA Palette Snoop : Disabled
Used to specify whether to monitor the palette of the VGA
card installed in a PCI slot.
Enabled .............. Monitors the palette.
Disabled ............. Does not monitor the palette.
$ DMA Channel (0, 1, 3, 5, 6, 7) : PnP
Used to specify which the DMA should be assigned to; “plug
and play” or ISA/EISA.
Assign the DMA to “plug and play” (PnP).
$ IRQ (3, 4, 5, 7, 9, 10, 11, 14, 15) : PCI/PnP
Used to specify which interrupt it should be assigned to: PCI
“plug and play” or ISA/EISA.
Assign it to PCI “plug and play” (PCI/PnP).
LOAD FAIL-SAFE DEFAULTS
Do not use this menu, if used your server may malfunction.
If by mistake you changed settings in this menu:
See “Resetting all setup options to their default values” on
page 130.
LOAD OPTIMIZED DEFAULTS
This menu is used to reset all BIOS setup options to their default
values. To do so, however, you also need to change settings in
other submenus.
See “Resetting all setup options to their default values” on
page 130.