Toshiba Magnia 550d - Manual (Page 72)

Connecting Hardware Devices
CPU module
55
Installing a CPU module
WARNING: Do not open or disassemble any part other than
those parts described in this manual, otherwise you be
vulnerable to an electric shock.
CAUTION: Never install or remove a CPU module after just
switching off the server. To avoid burn injuries, wait for the
heat around the CPU module to dissipate.
NOTE: When installing a CPU module, be sure to first unplug
the power cable of the server . Installing a CPU module while
the server is on could cause damage to the server or to the
CPU module.
CPU modules can be seriously damaged by static electricity
because they are precise electronic devices. Before installing
a CPU module, lightly touch a metallic part of the server to
discharge any static electricity from your body.
When installing a CPU module, first read “Before you start” of
this chapter and follow the instructions mentioned below.
1 If the server is in operation, shut it down and switch off the
power.
2 Unplug the power cable.
NOTE: Installation of a CPU module while the server is
switched on may cause damage the server or to the CPU
module.
3 Remove the front door panel and the side panel.
See “Removing and replacing the server panels” on page 21.