Toshiba Magnia SG30 - Manual (Page 70)

73 Using the Network
Sharing a printer
5.375 x 8.375 ver 2.1
Connecting the printer to the Magnia SG30
If you plan to use a printer with a USB connection, the printer
must be connected to the printer port on the back of the
Magnia SG30. If the printer is a network printer supporting a
LAN network connection, it should be plugged in to the
internal switch. Normally your network administrator does
this when setting up the LAN.
Magnia SG30 printer port
NOTE: Make sure the power for the printer is turned on before you
attempt to configure the network to use it.
Connecting a client computer to the network printer
Although the screen displays vary slightly between the
different Microsoft Windows operating systems, the way you
configure the network printer is much the same. You will
probably need the device driver diskette or CD that came with
the printer, as well as your original Microsoft Windows Setup
Disk.
Internal switch USB ports