Toshiba Magnia SG30 - Manual (Page 262)

273 Manually Configuring Clients for the Magnia SG30
Manually configuring clients with Windows NT 4.0, Windows
2000 and Windows XP operating systems
5.375 x 8.375 ver 2.1
Installing the NIC with the Windows NT ® operating
system
1 Click Start, Settings, Control Panel, and double-click
the Network icon.
2 If the message “Windows NT Networking is not
installed. Do you want to install it now?” appears, click
OK.
3 Follow the prompts, accepting all default values
presented after you have correctly identified your
network adapter card. Select to enable DHCP when (and
if) asked. You will need both your Windows NT Setup
Disk and your network adapter setup disk.
4 Restart the client computer.
The steps for completing the installation depend on the
requirements of the network interface. Follow the instructions
for each prompt. When installation is complete, you will need
to restart the computer.
Before restarting the computer, make sure that the Ethernet
cable is properly connected to both the network adapter card
and the Magnia SG30. After the computer restarts, you will
be ready to continue with your client configuration network
settings.
Installing the NIC with the Windows 2000 operating
system
1 Click Start, Settings, Control Panel, and double-click
the Add New Hardware icon.
The Add New Hardware Wizard appears.
2 Follow the prompts of the Wizard accepting all defaults.
Allow the operating system to search for your network
adapter card. If it does not find your network adapter card
as expected, or any errors occur, consult the installation
instructions supplied with the network adapter card.