Toshiba Magnia SG30 - Manual (Page 288)

300 System Recovery CD
5.375 x 8.375 ver 2.1
3 Insert the Magnia SG30 System Recovery CD into the
USB CDROM drive.
4 Reconnect the power cord to the Magnia SG30.
The LCD panel will display “Magnia SG30”.
5 Press and hold the LCD scroll button until the LCD panel
displays “Alternate Boot” and then release the LCD
scroll button.
The SG30 should begin booting from the USB CDROM
drive within 10-15 seconds. In a minute, the LCD panel
will display the following confirmation message: “Press
SCROLL to continue install”.
6 Press and hold the LCD scroll button for approximately 2
seconds. If you do not press the LCD scroll button within
20 seconds, the Magnia SG30 will power off and you will
need to repeat steps1-5. This step provides a safety
mechanism to avoid inadvertent reinstallation of the
Magnia SG30.
The LCD panel should now display “Installing SG30
Please Wait…”.
When installation is complete, the Recovery CD will be
ejected from the CDROM drive and the SG30 will reboot.
During the reboot, the SG30 will complete the installation by
auto-configuring itself. The LCD panel should display
“Configuring SG30 Please Wait…".
The Magnia SG30 will reboot one final time after the
configuration process is completed and the system is now
ready for use.
The entire recovery process will take approximately about 30
minutes to complete.