Toshiba Magnia SG30 - Manual (Page 263)

274 Manually Configuring Clients for the Magnia SG30
Manually configuring clients with Windows NT 4.0, Windows
2000 and Windows XP operating systems
5.375 x 8.375 ver 2.1
3 Follow the instructions on screen.
The steps for completing the installation depend on the
requirements of the network interface. Follow the instructions
for each prompt. When installation is complete, you will need
to restart the computer.
Before restarting the computer, make sure that the Ethernet
cable is properly connected to both the network adapter card
and the Magnia SG30. After the computer restarts, you will
be ready to continue with your client configuration network
settings.
Installing the NIC with Windows XP Virtual Private
Networking Adapter
To configure your network settings:
1 Open the Windows Start Menu on the Windows Taskbar.
2 Select Settings>Control Panel to display the Windows
Control Panel.
3 If not in the Classic View, select the Switch to Classic
View from the left frame.
4 Double-click Network Connections.
5 Select Create a New Connection from the left frame. If
prompted, enter the area code and close the dialog box.
The New Connection Wizard appears.
6 Click Next. The Network Connection Type page appears.
7 Select Connect the network at my workplace, and click
Next.
8 Enter the IP address for your Magnia SG30 and click
Next.
9 Click Finish.