DiGiCo SD Series - Manual (Page 90)

Chapter 2 - The Master Screen
2-56
2.13.16 Video Link (SD7 Only) .......................................................
The Setup>Video Link panel allows the routing of one of several different video signals to the console video screen. The
worksurface buttons to select between these 3 sources can be found at the top of the console's centre section and are dupli-
cated at the top of the on screen panel. There is also a Self button to send the console's own camera signal to the screen.
Local Video Source
Selection
Video to send to
other consoles
Activate feed
To define the source associated with each button, touch the white label box below the on screen label and a drop down menu
will appear.
Potential sources include the console's two external video inputs (Ext 1 & Ext 2) located on the back panel and any optocore
equipped SD7 engines that are connected. Optocore engines are identified by their Optocore Loop number (normally 1) and their
Optocore ID which can be seen and set at the top of the console's Network panel).
The lower part of the Video Link panel determines which video source is fed from the console to the video network. Only one
source can be sent at one time and this is done by pressing the Feed button beneath the required source.
Select the appropriate video format using the NTSC and PAL buttons, ensuring that all connected consoles are using the same
format.
The console's camera feed can also be sent as a Mirror image using the on screen buttons.
NOTE: The Options menu, which will appear beneath Video Link in the Setup menu if Waves is active, is
described in Section 5 of this chapter.