DiGiCo SD Series - Manual (Page 48)

Chapter 2 - The Master Screen
2-14
If the Select button at the base of the panel is active, the display can be used for adjusting the bank assignments of the session’s
channels. This function employs the ASSIGN FADERS LCD function mode. The channel's current assignment is shown in the
layer/bank box: The surface (L or R; Master fader assignments are not shown), layer (L) and bank (B).
Note that when new channels are added to a session, or when a session is created, all of the existing channels
can be assigned to the worksurface using the rebuild banks function within the Session Structure display.
In Select mode, the display can also be used for assigning a channel to the worksurface controls. This is done by touching a
channel within the list, and also results in the channel’s bank being displayed in the appropriate side section of the console. If the
channel appears more than once within the session layout, the lowest bank in which it appears is the one which will appear on
the worksurface.
With either Select or Edit active, touching in a channel's meter box will cause a small meter panel for the channel to be dis-
played in the Master screen. This is meter display remains active regardless of whether or not the channel itself is currently on
the worksurface. It is possible to permanently display up to 12 channels in this way. Pressing the View button at the bottom of
any of these meters also allows them to be snapped to a grid, sized to either large or small, removed, and moved between the
Master screen and Overview screen.
The most recent Preset used on the channel is also displayed, in the last preset box.