DiGiCo SD Series - Manual (Page 12)

Chapter 1 - Channel Types
1-5
The extent of the channel settings to be copied is selected using the scope buttons towards the bottom of the display. Each
button lightens to indicate that it is included in the copy function. The number of source channels to be copied is defined either by
selecting the appropriate grey numbered button, or by selecting the keypad button to the right of the numbered buttons, typing the
required number of source channels into the numeric keypad which appears, and pressing OK. Press the LCD button (shown
below) on the left-most source channel in order to action the channel copy. If more than one source channel has been selected,
the settings of appropriate number of channels to the right of the source channel will copy to the channels to the right of the
destination channel (The current Assigned channel).
For example, to copy the EQ settings on channels 1-8 to channels 9-16 respectively:
- Make channel 9 the Assigned channel and touch copy from
- In the scope area of the Copy Channels display, select only the eq button
- Set the number of channels to be 8.
- Press the LCD/select button on channel 1.