Allied Telesis AT-S60 - Manual (Page 99)

AT-S60 Command Line User’s Guide
97
Note
The selections 10mfauto, 100mhauto, 100mfauto, and 1000mfauto
cause a port to Auto-Negotiate to a lower speed and/or to half
duplex mode if required by the end node.
priority Specifies the port’s priority. Settings for this
parameter are:
nooverride A tagged frame’s priority is
determined by its tagged header. This
is the default setting.
lowpriority Tagged frames and untagged frames
received on the port are directed to
the low priority egress queue.
highpriority All tagged frames and untagged
frames received on the port are
directed to the high priority egress
queue.
Description
This command sets a port’s operating parameters. You can set more
than one parameter at a time with this command. For an explanation of
the port parameters, refer to the AT-S60 Management Software User’s
Guide.
Examples
The following command configures Port 8 on the line card in Slot 2 to
operate at 10 Mbps, half duplex:
set switch port=2.8 speed=10mhalf
The following command sets the wiring configuration to MDI-X and
disables flow control for Ports 2 through 6 on the line card in Slot 4:
set switch port=4.2-6 mdimode=mdix
flowcontrol=disable
The following command disables Ports 1 through 6 on the line card in
Slot 7:
set switch port=7.1-6 status=disabled