Allied Telesis AT-S60 - Manual (Page 128)

Chapter 11: File System Commands
126
SET CONFIG
Syntax
set config=filename
Parameter
config Specifies the name of a configuration file.
Description
This command sets the configuration file for a switch. The switch will use
the configuration file the next time it is rebooted or power cycled.
The configuration file must already exist in the switch’s file system. To
view the files in a switch’s file system, see SHOW FILE on page 127.
Configuration files have a .cfg extension.
To view the name of the configuration file the switch is currently using,
see SHOW CONFIG on page 51.
You do not need to use the SAVE CONFIGURATION command with this
command. A change to the current configuration file is saved
automatically.
Example
The following command sets the boot configuration file to
switch22.cfg
:
set config=switch22.cfg
The switch uses the switch22.cfg configuration file the next time it is
reset.