Allied Telesis AT-S60 - Manual (Page 155)

AT-S60 Command Line User’s Guide
153
SET RSTP
Syntax
set rstp [default] [priority=priority]
[hellotime=hellotime] [forwarddelay=forwarddelay]
[maxage=maxage]
[forceversion=forcestpcompatible|normalrstp]
Parameters
default Returns all bridge and port RSTP settings to the
default values. This parameter cannot be used with
any other command parameter. (This parameter
performs the same function as the RESET RSTP
command.)
priority Specifies the priority number for the bridge. This
number is used in determining the root bridge for
RSTP. The bridge with the lowest priority number is
selected as the root bridge. If two or more bridges
have the same priority value, the bridge with the
numerically lowest MAC address becomes the root
bridge. The range is 0 to 61,440 in increments of 4,096.
The range is divided into sixteen increments, as
shown in the following table. You specify the
increment that represents the desired bridge priority
value. The default value is 32,768, which corresponds
to increment 8.
Table 5 Bridge Priority Value Increments
Increment
Bridge
Priority
Increment
Bridge
Priority
0 0 8 32768
1 4096 9 36864
2 8192 10 40960
3 12288 11 45056
4 16384 12 49152
5 20480 13 53248
6 24576 14 57344
7 28672 15 61440