Allied Telesis AT-S60 - Manual (Page 200)

Chapter 16: VLAN and MVLAN Commands
198
SET VLANMODE
Syntax
set switch vlanmode=userconfigured|dotqmultiple|
multiple [uplinkport=port]
Parameters
vlanmode Controls the switch’s VLAN mode when the switch is
operating in the tagged VLAN mode. Options are:
userconfigured When the switch is operating in this
mode you can create your own
port-based and tagged VLANs. This
is the default setting.
dotqmultiple This option configures the switch
for the 802.1Q-compliant multiple
VLAN mode.
multiple This option configures the switch
for the non-802.1Q compliant
multiple VLAN mode.
uplinkport Specifies the port on the switch to function as the
uplink port when the switch is operating in one of the
two multiple VLAN modes. You can specify only one
port.
Description
You use this command to configure the switch for one of the multiple
VLAN modes or so that you can create port-based and tagged VLANs.
This command is only functional when the switch is operating in the
tagged VLAN mode. It is not functional when the switch is operating in
the Basic mode. To set the VLAN mode, see the SET SWITCH
SWITCHMODE on page 197.
If you select one of the multiple VLAN modes, you must also set an
uplink port. This is set with the UPLINKPORT parameter. You can specify
only one uplink port.
Note
For background information on the multiple VLAN modes, refer to
the AT-S60 Management Software User’s Guide.