Allied Telesis AT-S60 - Manual (Page 283)

AT-S60 Command Line User’s Guide
281
SET PORTACCESS PORT SUPPLICANT
Syntax
set portaccess port=port|all supplicant
[authperiod=integer] [heldperiod=integer]
[maxstart=integer] [startperiod=integer]
[name=string] [password=string]
Parameters
port Specifies the port whose Supplicant settings you want
to set. You can specify more than one port at a time.
To set all ports, specify ALL. The selected ports must
already be set to the Supplicant role. To set port role,
see SET PORTACCESS PORT ROLE on page 280.
authperiod Specifies the period of time in seconds that the
supplicant waits for a reply from the authenticator
after sending an EAP-Response frame. The range is 1
to 60 seconds. The default is 30 seconds.
heldperiod Specifies the amount of time, in seconds, the
supplicant refrains from retrying to re-contact the
authenticator in the event the end user provides an
invalid username and/or password. Once the time
period has expired, the supplicant can attempt to
log on again. The range is 0 to 65,535. The default
value is 60.
maxstart Specifies the maximum number of times the
supplicant will send EAPOL-Start frames before
assuming that there is no authenticator present.
The range is 1 to 10. The default is 3.
startperiod Specifies the time period, in seconds, between
successive attempts by the supplicant to establish
contact with an authenticator when there is no
reply. The range is 1 to 60. The default is 30.
name Specifies the username for the switch port. The port
sends the name to the authentication server for
verification when the port logs on to the network.
The username can be from 1 to 64 alphanumeric
characters (A to Z, a to z, and 1 to 9). Do not use
spaces or special characters, such as asterisks or
exclamation points. The username is case-
sensitive.