Allied Telesis AT-S60 - Manual (Page 98)

Chapter 7: Port Parameter Commands
96
broadcastfilter Controls the broadcast filter. Possible values are:
enabled The port accepts and forwards
broadcast frames.
disabled The port discards all ingress broadcast
frames.
backpressure Controls backpressure on the port. Possible values
are:
enabled Enables backpressure.
disabled Disables backpressure.
mdimode Sets the wiring configuration of the port. Possible
values are:
mdi Sets the port’s configuration to MDI.
mdix Sets the port’s configuration to MDI-X.
auto Automatically sets the port’s wiring
configuration to either MDI or MDI-X,
depending on the end node connected
to the port. This is the default setting.
This parameter applies only to twisted pair ports.
speed Sets the speed and duplex mode of the port.
Settings for this parameter are:
autonegotiate The port Auto-Negotiates both
speed and duplex mode.This is the
default setting.
10mhalf 10 Mbps and half-duplex mode.
10mfull 10 Mbps and full-duplex mode.
10mhauto 10 Mbps and half-duplex mode with
autonegotiation.
10mfauto 10 Mbps and full-duplex mode with
autonegotiation.
100mhalf 100 Mbps and half-duplex mode.
100mfull 100 Mbps and full-duplex mode.
100mhauto 100 Mbps and half-duplex mode
with autonegotiation.
100mfauto 100 Mbps and full-duplex mode
with autonegotiation.
1000mfull 1000 Mbps and full-duplex mode.
1000mfauto 1000 Mbps and full-duplex mode
with autonegotiation.