Allied Telesis AT-S60 - Manual (Page 159)

AT-S60 Command Line User’s Guide
157
portpriority Specifies the port’s priority. This parameter is used as a
tie breaker when two or more ports are determined to
have equal costs to the root bridge. The range is 0 to
240 in increments of 16. There are sixteen increments.
You specify the increment that corresponds to the
desired value. The default is 128, which is increment 8.
edgeport Defines whether the port is functioning as an edge
port. An edge port is connected to a device
operating at half-duplex mode and is not
connected to any device running STP or RSTP.
Selections are:
yes The port is an edge port. This is the
default.
no The port is not an edge port.
pointtopoint Defines whether the port is functioning as a point-
to-point port. This type of port is connected to a
device operating at full-duplex mode. Selections
are:
yes The port is an point-to-point port.
no The port is not an point-to-point port.
autoupdate The port’s status is determined
automatically. This is the default.
Table 7 Port Priority Value Increments
Increment
Bridge
Priority
Increment
Bridge
Priority
0 0 8 128
1 16 9 144
2 32 10 160
3 48 11 176
4 64 12 192
5 80 13 208
6 96 14 224
7 112 15 240