Set stp – Allied Telesis AT-S60 User Manual
Page 144
Chapter 13: STP Commands
142
SET STP
Syntax
set stp [default] [priority=priority]
[hellotime=hellotime] [forwarddelay=forwarddelay]
[maxage=maxage]
Parameters
default
Returns all bridge and port STP settings to the default
values. This parameter cannot be used with any other
command parameter. (This parameter performs the
same function as the RESET STP command.)
priority
Specifies the priority number for the bridge. This
number is used in determining the root bridge for
STP. The bridge with the lowest priority number is
selected as the root bridge. If two or more bridges
have the same priority value, the bridge with the
numerically lowest MAC address becomes the root
bridge.
The range is 0 to 61,440 in increments of 4,096. The
range is divided into sixteen increments, as shown in
the following table. You specify the increment that
represents the desired bridge priority value. The
default value is 32,768 (increment 8).
Table 3 Bridge Priority Value Increments
Increment
Bridge
Priority
Increment
Bridge
Priority
0
0
8
32768
1
4096
9
36864
2
8192
10
40960
3
12288
11
45056
4
16384
12
49152
5
20480
13
53248
6
24576
14
57344
7
28672
15
61440