Allied Telesis AT-S60 - Manual (Page 121)

AT-S60 Command Line User’s Guide
119
SET SWITCH MIRROR
Syntax
set switch mirror=destinationport port=sourceport
Parameters
mirror Specifies the destination port of the port mirror to
which you want to add new source ports. This port
must already be functioning as a destination port of a
port mirror. (For information on how to specify ports,
refer to Specifying Ports on page 17.)
port Specifies the new source port(s) for an existing port
mirror. You can specify more than one port, but there
can be only one source port per line card.
Description
This command specifies new source ports for an existing port mirror. It is
similar to the ADD SWITCH MIRROR command. They both add new
source ports to a port mirror. Where they differ is that with this
command the new source ports replace the existing source ports. With
the ADD SWITCH MIRROR command, the new source ports are added to
the existing source ports.
Example
The following command specifies Port 4 on the line card in Slot 6 as the
new source port for a port mirror. The destination port is Port 4 on the
line card in Slot 1:
set switch mirror=1.4 port=6.4