Allied Telesis AT-S60 - Manual (Page 74)

Chapter 5: SNMP Community Strings and Trap Commands
72
CREATE SNMP COMMUNITY
Syntax
create snmp community=community
[access=read|write] [open=yes|no]
[traphost=ipaddress] [manager=ipaddress]
Parameters
community Specifies a new community string. The maximum
length of a community string is 15 alphanumeric
characters.
access Specifies the access level of the new community
string. Options are “read” for read only access and
“write” for both read and write access. The default is
“read.”
open Specifies the open or closed status of the community
string. The options are:
yes The community string is open, meaning that
any management workstation can use the
string to access the switch.
no The community string is closed, meaning that
only those management workstations whose
IP addresses are assigned to the string can use
it to access the switch. You can assign a
management IP address to the string using the
MANAGER option in this command. The
default setting for a community string is
closed.
traphost Specifies the IP address of a trap receiver to receive
system traps.
manager Specifies the IP address of a management station that
can use the community string to access the switch.
This option applies if you specify the status of the
community string as closed. A community string can
have up to eight IP addresses of management
workstations, but only one IP address can be assigned
with this option.