Allied Telesis AT-S60 - Manual (Page 112)

Chapter 9: Port Trunking Commands
110
SET SWITCH TRUNK
Syntax
set switch trunk=name speed=10_100m|1000m
Parameters
trunk Specifies the name of the port trunk whose speed
you want to change. The name is case-sensitive.
speed Specifies the new speed of the trunk. Options are:
10_100m The ports of the trunk are operating at
10 or 100 Mbps.
1000m The ports of the trunk are operating at
1000 Mbps.
Description
This command changes the designated speed of an existing port trunk.
Example
The following command changes the designated speed of the port trunk
named Load11 to 10 and 100 Mbps:
set switch trunk=Load11 speed=10_100m