Allied Telesis AT-S60 - Manual (Page 183)

AT-S60 Command Line User’s Guide
181
SHOW MSTP
Syntax
show mstp [portconfig=ports|all]
[portstate=ports|all] [msti] [cist]
[mstivlanassoc]
Parameters
portconfig Specifies a port. You can specify more than one port at
a time. To display all ports, use ALL. For a list of the
MSTP information displayed by this parameter, refer to
Description below.
portstate Specifies a port. You can specify more than one port at
a time. To display all ports, use ALL. For a list of the
MSTP information displayed by this parameter, refer to
Description below.
msti Displays a list of the MSTIs on the switch and their
associated VLANs. The list does not include the CIST.
cist Displays the CIST priority and the VLANs associated
with CIST.
mstivlanassoc Displays a list of the MSTIs on the switch, including the
CIST, and their associated VLANs.
Note
You can specify only one parameter at a time in this command.
Description
This command displays MSTP parameters. For definitions of the MSTP
terms used below, refer to the AT-S60 Management Software User’s
Guide.
Entering SHOW MSTP without any parameters displays the following
MSTP settings:
❑ MSTP status
❑ Force version
❑ Hello time
❑ Forwarding delay