Allied Telesis AT-S60 - Manual (Page 55)

AT-S60 Command Line User’s Guide
53
SHOW IP
Syntax
show ip interface=1
Parameters
interface Specifies the switch’s interface number. This value is
always 1.
Description
This command displays the current values for the following switch
parameters:
❑ IP address
❑ Subnet mask
❑ Default gateway
To set the IP address and subnet mask, refer to SET IP on page 42. To set
the default gateway address, refer to SET IP ROUTE on page 44.
Example
The following command displays the IP address, subnet mask, and
default gateway of the switch:
show ip interface=1