Enable portaccess – Allied Telesis AT-S60 User Manual

Page 278

Text mode
Original mode

Chapter 26: 802.1x Port-Based Access Control Commands

276

ENABLE PORTACCESS

Syntax

enable portaccess

Parameters

None.

Description

This command enables 802.1x Port-based Access Control on the switch.

Note

Enabling or disabling Port Access Control can only be performed in
a local management session.

Note

You must activate and configure the RADIUS protocol on the switch
before you can activate port-based access control. Refer to SET
AUTHENTICATION on page 292.

Example

The following command enables 802.1x Port-based Access Control on
the switch:

enable portaccess