Allied Telesis AT-S60 - Manual (Page 38)

Chapter 3: Basic Switch Commands
36
RESET IP
Syntax
reset ip interface=1
Parameter
interface Specifies the interface number. This value is
always 1.
Description
This command returns the IP address, subnet mask, and gateway
address to their default values, which are:
❑ IP address: 0.0.0.0
❑ Subnet mask: 0.0.0.0
❑ Default gateway address: 0.0.0.0
To return one of the above parameters to its default value, refer to
PURGE IP on page 34.
Example
The following command returns the switch’s IP address, subnet mask,
and gateway address to their default values:
reset ip interface=1