Allied Telesis AT-S60 - Manual (Page 204)

Chapter 17: GARP VLAN Registration Protocol Commands
202
DISABLE GARP
Syntax
disable garp=gvrp [gip]
Parameters
garp Specifies the GARP application you want to disable.
The only GARP application supported by AT-S60
management software is GVRP.
gip Disables GARP Information Propagation (GIP).
Note
The online help for this command contains an STP option. The
option is not supported.
Description
This command disables GVRP on the switch. Once disabled, the switch
will not learn any new dynamic GVRP VLANs or dynamic GVRP ports.
This command can also be used to disable GIP.
Note
Do not disable GIP if the switch is running GVRP because GIP is
required for proper operation of GVRP.
Examples
This command disables GVRP on the switch:
disable garp=gvrp
This command disables GIP only:
disable garp=gvrp gip