Allied Telesis AT-S60 - Manual (Page 96)

Chapter 7: Port Parameter Commands
94
RESET SWITCH PORT
Syntax
reset switch port=port
Parameter
port Specifies the port to reset. You can specify more than
one port at a time. (For information on how to specify
ports, refer to Command Formatting on page 17.)
Description
This command resets a port. The reset takes less that a second to
complete. You might reset a port if it is experiencing a problem
establishing a link with its end node. The port retains its current
operating parameter settings.
Example
The following command resets Ports 5 through 8 on the line card in Slot
7:
reset switch port=7.5-8