Allied Telesis AT-S60 - Manual (Page 281)

AT-S60 Command Line User’s Guide
279
quietperiod Sets the number of seconds that the switch remains in
the quiet state following a failed authentication
exchange with the clien
t. The default value is 60
seconds. The range is 0 to 65,535 seconds.
txperiod Sets the number of seconds that the switch waits for a
response to an EAP-request/identity frame from the
client before retransmitting the request. The default
value is 30 seconds. The range is 1 to 65,535 seconds.
reauthperiod Enables periodic reauthentication of the client, which
is disabled by default. The default value is 3600
seconds. The range is 1 to 65,535 seconds.
supptimeout Sets the switch-to-client retransmission time for the
EAP-request frame. The default value for this
parameter is 30 seconds. The range is 1 to 600
seconds.
servtimeout This is the timer used by the switch to determine
authentication server timeout conditions. The default
value for this parameter is 30 seconds. The range is 1
to 65,535 seconds.
maxreq This parameter specifies the maximum number of
times that the switch retransmits an EAP Request
packet to the client before it times out the
authentication session. The range is 1 to 10
retransmissions and the default is 2.
Description
This command configures the settings for ports in the Authenticator
role.
Example
The following command sets the servertimeout parameter to 200
seconds for Port 7 on the line card in Slot 2:
set portaccess port=2.7 authenticator
servtimeout=200