Allied Telesis AT-S60 - Manual (Page 93)

AT-S60 Command Line User’s Guide
91
SET SWITCH STACKMODE
Syntax
set switch stackmode=[master|slave|unavailable]
Parameter
stackmode Specifies the enhanced stacking mode of the switch.
Possible settings are:
master Specifies the switch’s stacking
mode as master. A master switch
must be assigned an IP address and
subnet mask.
slave Specifies the switch’s stacking
mode as slave. A slave does not
need an IP address. This is the
default setting for a switch.
unavailable Specifies the switch’s stacking
mode as unavailable. A switch with
this status cannot be managed from
an enhanced stack. It can be
managed locally through its RS-232
Terminal Port or remotely if it is
assigned an IP address and subnet
mask.
Description
This command sets a switch’s enhanced stacking status.
Note
To determine the master or slave status of a switch, use SHOW
SWITCH on page 55.
Example
The following command sets the switch’s stacking status to master:
set switch stackmode=master