Allied Telesis AT-S60 - Manual (Page 132)

Chapter 12: File Download and Upload Commands
130
destfile Specifies the name under which the file is to be
stored on the switch.
server Specifies the IP address of network node containing
the TFTP server software. This parameter is required
for a TFTP download.
file Specifies the path and filename of the file you are
downloading onto the switch. This parameter is
required for a TFTP download.
switchlist Specifies the switches in an enhanced stack to which
to download the software image or file from the
master switch. Switch numbers are displayed with
the SHOW REMOTELIST command. This parameter is
used with the REMOTESWITCH parameter.You can
specify more than one switch at a time (for example,
1,3,4).
Description
You can use this command to download the following types of files onto
the switch:
❑ AT-S60 software image
❑ Configuration file
❑ Public key certificate
❑ Public key certificate enrollment request
❑ Encryption key
This command can download files in the following ways:
❑ From a management workstation to a slave or master switch
using Xmodem or TFTP
❑ From a master switch to other switches in an enhanced stack
The METHOD parameter states the type of download. There are three
possible types of downloads. A TFTP download uses the TFTP client
software on the switch to download a file from a TFTP server on your
network. The file that you are downloading must be stored on the TFTP
server. You can perform this type of download from either a local or
Telnet management session.