Allied Telesis AT-S60 - Manual (Page 103)

AT-S60 Command Line User’s Guide
101
SET SWITCH PORT SECURITYMODE
Syntax
set switch port=port
[securitymode=automatic|limited|secure|locked]
[learn=integer]
[intrusionaction=discard|trap|disable]
[participate=yes|no]
Parameters
port Specifies the port where you want to set security.
You can specify more than one port at a time. (For
information on how to enter ports, refer to
Specifying Ports on page 17.)
securitymode Specifies the port’s security mode. Options are:
automatic Disables security on the port. This is the
default setting.
limited Sets the port to the Limited security
mode. The port learns a limited number
of dynamic MAC addresses, set with the
LEARN parameter.
secure Sets the port to the Secure security
mode. The port accepts frames based
only on static MAC addresses. After you
have activated this security mode on a
port, you must enter the static MAC
addresses of the nodes with frames the
port is to accept. To add static MAC
addresses, use the command ADD
SWITCH FDB on page 216.
locked Sets the switch to the Locked security
mode. The port stops learning new
dynamic MAC addresses. The port
forwards frames based on static MAC
addresses and on those dynamic
addresses it has already learned.